JD Series Specifications OPERATOR INTERFACE Status Annunciators: 2; Red LED for output; Green LED for input; Variable intensity. Functional Test Pushbutton: Fixed at 50% of span range; Imposes pre-adjusted signal on the output, independent of any input signal. Calibration Method: Fixed Range; Calibrated signal input; Fine tuning potentiometer; Non- interactive zero and span signals eliminate “crosstalk” influences. Adjustments: Integral potentiometers & switches; Zero offset fine FUNCTIONAL PARAMETERS Linearity: Better Than Or Equal To 0.1% Full Scale (FS) Measurement Response Rate: 70ms typical; 10ms available (Optional) Span Range @ Full Scale: Factory set; Select 0 To 1 mV/V (minimum); 0 To 200 mV/V (maximum) Zero Offset: Fine: 0-10%; Coarse: Factory set pre-load offset available Bridge Excitation Voltage: Factory adjustable: 4-10 VDC; Field adjustable: 10% of Factory setting Excitation Current Rating: 30 mA maximum Excitation Stability: .005%/°F (.01%/°C) Low Pass Filter: 20 Hz; Other settings are factory adjustable Common Mode Rejection: 100dB (minimum) Input Impedance: 200K (typical) Power (Standard): 115 VAC ±10% @ 50/60Hz; 2.5W (maximum) Power (Options): 230 VAC ±10% @ 50/60Hz; 2.5W (maximum) 12 VDC ± 5% 125 mA maximum; or 12 VDC ± 10% 2.5 W maximum ENVIRONMENTAL Operating Temperature Range: -10° To +60 °C / 14° F To 140°F Storage Temperature Range: -20° To +70° C / -4° F To 158° F Temperature Stability: Better Than 0.02% of Span/°C Humidity Range: 0 To 95% RH; Non-condensing Enclosure Construction: High impact polycarbonate; 11-pin plug base Enclosure Dimensions: 2.75” high X 2.38” wide X 1.75” deep Weight: > 1 lbs. (0.5 kg) Warranty: One year; Limited OUTPUT Output Ranges: Voltage: 0-1, 0-5, 1-5, 0-10, ± 5 or ± 10 VDC Current: 0-20 mA or 4-20 mA Drives up to 1000 ohm load resistance Output Capability: Voltage: ± 10VDC @ ± 10 mA Current: 25 mADC; 12 V compliance OPTIONS Relay Modules: Setpoint adjustment 0 to 100% of Span; Deadband adjustment 1 to 100% of Span; Single or double relay modules; 7A contacts @ 240 VAC (resistive load); 3.5 A contacts @ 240 VAC (inductive load). Other Options: 11-pin sockets, DIN or surface mount; Aluminum DIN rail; NEMA 4/4X enclosures; Explosion-proof enclosures ; DC power. 100